SILICONE EMULSION PRODUCTION INFORMATION DESCRIPTION: M.R.Emulsion is a Mould Release Agent for Rubber and Plastic Industries. In Rubber Ind. like tyres, Tubes, Fan belts, Hoses, Gaskets and many other Rubber parts, M.R. Emulsion acts as an efficient and economical release, and shining Agent. PROPERTIES: M.R.EMULSION does not gum, or form carbonaceous deposits that build up on process equipment to cause expensive product rejection. Release is complete, clean and surface finishes are blemish free and sharp in details. It improves safety and working conditions and acts an antis tick material and eliminates need. It is even non-volute and oxidation resistant. TYPICAL PHYSICAL PROPERTIES CHEMICAL NATURE DIMETHYLPOLYSILOXANE Sp. Gr. 0.98 Nature Non-Ionic PH 6.5 To 7 Diluents Water Solids 20 to 60% As per request METHOD OF APPLICATIONS: Before applying M.R. Emulsion the mould should be completely wetted which assures a continuous, stable Parting film and helps minimize cost per moldings. Thus it eliminates sticking in extruders, moulds, calendars, and other equipment’s throughout the rubber processing Operation. The technique for applying M.R.EMULSION varies because of deference in production equipment. M.R.EMULSION may spray automatically or applied manually by swabbing, wiping, dipping or hand spraying. PACKING: IN 1 Kg, 5Kgs, 30Kgs & 50 KGS Plastic Jar. NOTE: M.R.EMULSION other better shines than any other commercial 30% Silicone Emulsion. Non-Warranty: The information given in this bulletin is based on our experience that we believe to be Reliance but we cannot accept any responsibility for operations not under Our direct control, it is offered solely for your consideration, innovation and verification.